DB9 D-sub nut driver bit|
||hexbit = 3/16" nut driver bit optimized for DB9 / D-Sub hex nuts.
1/4" hex end fits common electric screwdrivers.
||Anywhere D-Sub connectors are found... For the electric screwdriver, we are
happy with the Bosch GSR 10.8 V-EC HX (brushless motor,
photo below), but almost anything that takes 1/4" hex bits will work.
Buy nice, or buy twice...
||In our experience, common 3/16" nuts are too deep for hex nuts, and their
diameter is usually too large to fit without rubbing the connector shell.
||Please set minimum torque on your electric driver - the thread in the connectors
strips rather easily.
|© 2002-2018 PC Engines GmbH. All rights reserved